You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I have a nophead Mendel90. A characteristic of this machine's firmware is that bed centre is at 0,0.
This means that X and Y coordinates have a range of -100 to +100 (with -100,-100 being at the bed rear-right).
Through observation I have determined that this plugin only seems to work with positive coordinates. I don't see any forced retractions occuring on the front-right and rear-right of the bed where X and Y have negative values.
Regards,
Neil Darlow
The text was updated successfully, but these errors were encountered:
Hi,
I have a nophead Mendel90. A characteristic of this machine's firmware is that bed centre is at 0,0.
This means that X and Y coordinates have a range of -100 to +100 (with -100,-100 being at the bed rear-right).
Through observation I have determined that this plugin only seems to work with positive coordinates. I don't see any forced retractions occuring on the front-right and rear-right of the bed where X and Y have negative values.
Regards,
Neil Darlow
The text was updated successfully, but these errors were encountered: