Switch your drone to wifi mode if you havn't do so.
- Turn on your drone if you haven't done so.
- Wait until your drone blinks yellow light at high frequently.
- Using your laptop, connect to the wifi named
TELLO-<droneId>
.
WARNING: Please read the entire section before proceed. WARNING
WARNING: Please read the entire section before proceed. WARNING
- Put on your safety goggle.
- Make sure that the situation is suitable for flying.
- Launch IntelliJ IDEA.
- Create a new project or open an existing project.
- DOUBLE CHECK if it is SAFE for your drone to takeoff and move around.
- Click the Run button.
- Watch your drone flying. Closely (but not physically too close) monitor your drone. If anything goes wrong, click the Stop button immediately.
- The drone takes 15 seconds to land after you hit the Stop button.
- Do not try to catch the drone by your hand.
- Turn off your drone. Leave the battery inside the drone.
- Use the Micro USB cable to charge the battery through the drone.
- Disconnect the cable when battery is fully charged.
- Remove battery from the drone.