You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Using
Radiomaster TX16S (Edge Tx 2.7.0)
HappyModel ES24TX 2400 TX with ELRS 2.2
HappyModel ES24TX 2400 TX with ELRS 2.5
If I turn the radio on with an ELRS model selected, I get a
Status "500 Hz 1 Err"
indicated on the Model Setup page, with either module fitted,
I am not experiencing any control issues that I know of, but am concerned something is not as it should be.
The count does not appear to go above 1, so this seems a different problem to #2091
Expected Behavior
I would expect the status line to show
Status "500 Hz 0 Err"
Steps To Reproduce
Turn on radio with ELRS model selected
Go to Model Setup page
Scroll into the External RF block
Locate the Status metric
Version
2.7.0
Transmitter
Radiomaster TX16S
Anything else?
No response
The text was updated successfully, but these errors were encountered:
There will always be a one or two errors due to how the module responds from power up (i.e. whether it initially responds at the baud rate set or has to run auto-baud tuning). You'll also get one or two errors when you change the serial baud rate, etc. I think any change to this will be cosmetic at best, and downright misleading at worst. As a comparison, the RM TX16S and Jumper T-Lite that I have (which both have internal ELRS modules) will show 0 errs right from power up. Whereas my HM ES24TX module always has one error.
This is not a bug, but something that you need to know is normal and expected.
Is there an existing issue for this problem?
What part of EdgeTX is the focus of this bug?
Transmitter firmware
Current Behavior
Using
Radiomaster TX16S (Edge Tx 2.7.0)
HappyModel ES24TX 2400 TX with ELRS 2.2
HappyModel ES24TX 2400 TX with ELRS 2.5
If I turn the radio on with an ELRS model selected, I get a
Status "500 Hz 1 Err"
indicated on the Model Setup page, with either module fitted,
I am not experiencing any control issues that I know of, but am concerned something is not as it should be.
The count does not appear to go above 1, so this seems a different problem to #2091
Expected Behavior
I would expect the status line to show
Status "500 Hz 0 Err"
Steps To Reproduce
Turn on radio with ELRS model selected
Go to Model Setup page
Scroll into the External RF block
Locate the Status metric
Version
2.7.0
Transmitter
Radiomaster TX16S
Anything else?
No response
The text was updated successfully, but these errors were encountered: