In the event you are unable to access your AP that has been flashed with the FRC|reg| OpenWRT firmware, there is a recovery procedure available to boot to the backup partition. This will restore all settings to the image defaults (as described in :doc:`Default Settings <default-settings>` ) which should allow you to access the device again.
- Power off router with power switch.
- Turn power back on and Power LED will light. As soon as all LEDs turn off (~2s), power off router with power switch
- As soon as all LEDs turn off (~2s), power off router with power switch
- Turn power back on and Power LED will light. As soon as all LEDs turn off (~2s), power off router with power switch
- As soon as all LEDs turn off (~2s), power off router with power switch
- Turn power back on and Power LED will light. As soon as all LEDs turn off (~2s), power off router with power switch
- As soon as all LEDs turn off (~2s), power off router with power switch
- Turn power back on and allow router to fully boot. It should now be booted to the alternate firmware partition
- It should now be booted to the alternate firmware partition