You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
There is a discrepancy in schematic (Cheetah_Board V2.0_SCH.pdf) of the board and pin definitions, i2c2 should be PB10/PB11, but in schematic it's PB10/PB3? There is also a note about capacitor on PB11 that disables i2c, so what is the state of the hardware? I'm trying to connect ssd1306 display via i2c to be used in klipper, but it timeouts on PB10/PB11.
The text was updated successfully, but these errors were encountered:
There is a discrepancy in schematic (Cheetah_Board V2.0_SCH.pdf) of the board and pin definitions, i2c2 should be PB10/PB11, but in schematic it's PB10/PB3? There is also a note about capacitor on PB11 that disables i2c, so what is the state of the hardware? I'm trying to connect ssd1306 display via i2c to be used in klipper, but it timeouts on PB10/PB11.
The text was updated successfully, but these errors were encountered: