You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
select the "vent_binder" subshapebinder in "SLIDE_IN"
pocket the "vent_binder"
observe that the pocket appears to be along the z axis as it appears in the section below the "vent binder" instead of along the y axis where I would expect it.
note that the "thread_holes_2" pocket, which is also based on a subshapebinder from "MAIN_CASE" works fine (but it's along the z-axis)
Issue imported from https://tracker.freecad.org/view.php?id=4767
Original report text
Forum Post
When making pockets with sub-shapebinders, FreeCAD insists on pocketing along the z-axis.
Steps to reproduce
FreeCAD Info
Other bug information
The text was updated successfully, but these errors were encountered: