You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Since 0.20 release, FEM Pipeline legends are always in SI units so displacements are in m, stresses in Pa and so on. However, in many cases, it is much more clear to operate on SI(mm) units, for example (displacements in mm, stresses in MPa). Thus, it would be good to add an option to change the units of the displayed FEM result legends.
Anything else?
No response
Code of Conduct
I agree to follow this project's Code of Conduct
The text was updated successfully, but these errors were encountered:
It's very awkward to display stress when a system is pressurized to 30 MPa, which is common for high pressure air, the display is very busy and the font is too small. I'm trying to see stresses of 450-1000 MPa, viewing 4.500000e+8 Pa or whatever is rather silly. It makes this module seem a bit amateur in it's capabilities, especially when shown publicly as compared to other FEA displays. At least that is the feedback I am getting, attempting to show that FreeCAD can indeed do FEA.
I don't know the project. On the surface, the changes don't sound that hard. Divide by 1e6 and display. At least that is what I used to do with MatplotLib when I wanted more professional legends. Is it far more complicated than that? (Wouldn't surprise me if it was.)
Once the numbers are on the order of three digits, it would be nice to slightly improve the font for readability. I am no longer young, my visual acuity is poorer than in my youth. The current font is hard to read.
Would be good to push this up a bit. It is nearly a year old. Thanks.
Is there an existing request for this?
Forums discussion
https://forum.freecadweb.org/viewtopic.php?f=18&t=68502
Subproject(s) affected?
FEM
Idea description
Since 0.20 release, FEM Pipeline legends are always in SI units so displacements are in m, stresses in Pa and so on. However, in many cases, it is much more clear to operate on SI(mm) units, for example (displacements in mm, stresses in MPa). Thus, it would be good to add an option to change the units of the displayed FEM result legends.
Anything else?
No response
Code of Conduct
The text was updated successfully, but these errors were encountered: