You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
A workflow in the [MeshPart WB] where 3D surfaces, that need to be 2D to be cut out of a material to then be assembled again to create a 3D shape, would need to be parametric/automatic.
To come up with variations of the same base design it would be great if not only the 3D surfaces were parametric/automatic but also the following steps of meshing and unwrapping.
Anything else?
No response
Code of Conduct
I agree to follow this project's Code of Conduct
The text was updated successfully, but these errors were encountered:
Is there an existing request for this?
Forums discussion
https://forum.freecad.org/viewtopic.php?p=671251
Subproject(s) affected?
Other (specify in description)
Idea description
A workflow in the [MeshPart WB] where 3D surfaces, that need to be 2D to be cut out of a material to then be assembled again to create a 3D shape, would need to be parametric/automatic.
Theoretically similar to: https://www.youtube.com/watch?v=1JyiMy8rBv4
To come up with variations of the same base design it would be great if not only the 3D surfaces were parametric/automatic but also the following steps of meshing and unwrapping.
Anything else?
No response
Code of Conduct
The text was updated successfully, but these errors were encountered: