Camera Settings Control for K1 Max with new hardware version #444
Replies: 7 comments 33 replies
-
That is correct! Creality changed the camera module hardware, as such the new hardware does not respond to the commands exposed on the older hardware. If anyone is a hardware/firmware hacker and can find out what commands it can/does accept or MAKE it accept commands it would be welcomed greatly. IMHO, the new camera sucks by comparison, if you add extra lighting you cannot make adjustments to compensate :( |
Beta Was this translation helpful? Give feedback.
-
Does lsusb reveal any information on the new camera? The older one is this http://linux-hardware.org/?id=usb:0c45-6366 |
Beta Was this translation helpful? Give feedback.
-
Is the new revision of camera better in any way? |
Beta Was this translation helpful? Give feedback.
-
I have the old Camera and I am facing this error " You have the new hardware version of the camera and it's not compatible!" when trying to install the camera control script. |
Beta Was this translation helpful? Give feedback.
-
I just tried to connect to the camera via serial, I soldered some wires to the PCB on TX, RX and GND and I managed to connect. Unfortunately access is password protected. Serial init OK!jz_serial_init ok spl_sfc_nor_load_kernel ... uImage size = [3628865] Ingenic-uc1_1 login: INFO(KIVA): AntiCopy_Verify ... INFO(KIVA): module_ucamera_init ...ok
|
Beta Was this translation helpful? Give feedback.
-
|
Beta Was this translation helpful? Give feedback.
-
I just did a rom dump. |
Beta Was this translation helpful? Give feedback.
-
Curious if this is something that can be requested or not. I am going to assume it is not a bug, but rather a case of being unsupported, since the script basically states that "You have the new hardware version of the camera and it's not compatible!"
Beta Was this translation helpful? Give feedback.
All reactions