- uses the sysparam led_pin and starts blinking only from ota_init onwards
- cosmetic fixes to design diagram
- these were showing high watermark errors in testing 1.9.8
- cosmetic changes to count-down messages
- wifi won't start until user_init is over so created a pre-wifi-task
- a tiny fix in wifi_config solves an incompatability with new Safari versions (macOS 10.15.4 and iOS 13.4)
- a non-working attempt to make sure the count down messages show up in
nc -kulnw0 45678
- the wifi page allows setting info about the led pin.
- choices are for GPIO 2, 4, 5, 13, 14, 15 since these are the least likely to create hardware issues
- default is that the led is connected to +Vcc and is active on '0'
- if your led connects to GND then you can check the box to indicate it is active on '1'
- the led info is stored in sysparam_int8 led_pin and parsing is done for all values between -15 and 15
- the values below zero indicate the led is active on '1'
- Also, if count>4 from rboot4lcm then a message counting down from 10 allows abort in case of mistake
- It is recommended to ALWAYS monitor LCM via
nc -kulnw0 45678
to check for these messages
- The uploading of a bootloader to sector 0 should replicate the flags1 and flags2 values of the previous bootloader. Else it will break the access to the flash in case it is not compatible.
- esp-open-rtos used has been updated from esp-open-rtos#a721fb0 to esp-open-rtos#bc97988
- change the verification of the signature of otamain.bin prior to downloading this file instead of afterwards