-
Notifications
You must be signed in to change notification settings - Fork 8
Hardware setup
HomeKid edited this page Sep 26, 2019
·
15 revisions
-
The sensor using I2C bus,
SDA
andSCL
pins must be pulled up via 10K resistors from 3.3V according to iAQ Core C's datasheet! See schematic below! -
I2C bus pins on ESP12E/F boards are
GPIO5 - SCL
andGPIO4 - SDA
. If you are using Wemos D1 mini, I2C pins areSCL - D1
andSDA - D2
! -
This sensor also has an option for resetting to factory default. Long pressing for 10 seconds a button connected to
GPIO0 and GND
will reset the sensor! -
DHT22 sensor's data pin is connected to
GPIO12 (Wemos D6)
via 4.7K pullup resistor from 3.3V!
Prefix | Value | Package |
---|---|---|
R1 | 10K Ω | SMD 0805 |
R2 | 10K Ω | SMD 0805 |
R3 | 4.7K Ω | SMD 0805 |
R4 | 10K Ω | SMD 0805 |
R5 | 10K Ω | SMD 0805 |
C1 | 100nF | SMD 0805 |
C2 | 10uF | SMD 0805 |
C3 | 10uF | SMD 0805 |
C4 | 100nF | SMD 0805 |
C5 | 100nF | SMD 0805 |
IC1 | AMS1117-3.3 | SOT223 |
Reset | Tactile 90 degree button | SMD 3x6x3.5mm |
Serial | 2.54mm 4P header | (optional) |
H1 | 5V power | old microUSB female cable |