grass failed to build on 10.8.2

[auklet]

This used to work fine. Also tried with --env=std and on a clean slate (homebrew installed in an empty /usr/local/) with the same results.

Thank you for the help.
Martin

Here is the gist
https://gist.github.com/4741911

[jacknagel]

Can you compile other stuff? These syntax errors in system headers look bad.

[scooterw]

I was getting similar errors and got it to build using brew install grass --use-llvm. See issue #14693.

[auklet]

YES, that did it! Thank you so much. I think I saw the --use-llvm switch before, but forgot about it. May be this tip could be added to the troubleshooting page? I looked around quite a lot before opening my ticket. Issue #14693 also never showed up in the brew output in contrast to many other occasions when builds fail. I googled the error messages a fair bit but had no luck.

Best and again, thank you for your help, much appreciated!

Martin

On 8 Feb 2013, at 19:33 , Scooter Wadsworth notifications@github.com wrote:

I was getting similar errors and got it to build using brew install grass --use-llvm. See issue #14693.

—
Reply to this email directly or view it on GitHub..

This electronic communication is governed by the terms and conditions at
http://www.mun.ca/cc/policies/electronic_communications_disclaimer_2012.php

[auklet]

Thank you for the reply, Jack! Yes, everything else I tried does compile. Following the hint from another member, I had success using:

brew install grass --use-llvm

Thank you for the help and happy brewing,

Martin

On 8 Feb 2013, at 14:18 , Jack Nagel notifications@github.com wrote:

Can you compile other stuff? These syntax errors in system headers look bad.

—
Reply to this email directly or view it on GitHub..

This electronic communication is governed by the terms and conditions at
http://www.mun.ca/cc/policies/electronic_communications_disclaimer_2012.php

[adamv]

Please don't post "terms and conditions".