This obsfunction follows a similar subroutine of GSI Observer and first computes the wind speed difference between the observation and model. Then, if model wind speed is greater than observed wind speed, a residual of the two wind components is computed as error_min
and error_max
(since it may have been inflated from prior steps). These error bound limits were found in a GSI fix file. Lastly, the quotient of the residual over obsError is calculated as the final output value that is tested against a maximum value of gross error to reject the observation.
error_min
and error_max
are required parameters set to the lowest/highest value desired for calculated ObsError value. Typically this was supplied by a GSI fix file.
original_obserr
is the optional group name for the original value of ObsError before any inflation steps. This option is typically used for testing against prior datasets, but within UFO, the option is not needed because it would be the starting value of ObsErrorData.
test_hofx
is the optional group name for the hofx value used when testing against a reference value such as GsiHofX
when using the test_ObsOperator.x application.
- filter: Bounds Check
filter variables:
- name: eastward_wind
- name: northward_wind
test variables:
- name: SatWindsSPDBCheck@ObsFunction
options:
error_min: 1.4
error_max: 20.0
maxvalue: 1.75 # gross error * 0.7