-
-
Notifications
You must be signed in to change notification settings - Fork 1.6k
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Map takes forever to load, or doesn't load at all... #14598
Comments
This issue is stale because it has been open 30 days with no activity. Remove stale label or comment or this will be closed in 7 days |
I know that this is not a priority, but I wouldn't like it to get lost.... |
Hi, same here ! |
Hi, I have the same.
installed by docker-compose:
|
This issue is stale because it has been open 30 days with no activity. Remove stale label or comment or this will be closed in 7 days |
I have the same issue UPDATE: it just takes much longer than "2 minutes". Especially when you have "dead" devices. |
I now have this problem with zigbee2mqtt 1.33.2 (it wasn't the case before) even when waiting overnight (and not only 2mn 😁 ). |
Hello, following this - mine has been fine for months - i'm on 1.35.1-1 using a sonoff dongle coordinator plugged into usb on a NUC running HA in proxmox. I'm now getting this behaviour and need to restart the zigbee2mqtt bridge every day as some devices become unresponsive and the map never loads (unless after a restart). I am starting to look at usb extension lengths to move it further away from interference but I don't really know if that is the issue or if its the coordinator, any of the devices or something else. Wifi is via Eero which I dont think I can change channels on. Would just like a steer on what I should really be concentrating on first. Thanks |
If it's any help: when these problems occur, I've found that completely switching off (electrically) my system (Khadas + HA supervised + SkyConnect + Z2M), and not just rebooting it, means that it works for several days! |
Thanks - I will try anything. I got a 2m usb2 extension (was 1m usb3) and also found a device (smart plug) not powered on at the wall switch in the network - so enabled that. Will see - thanks for the response. I notice a few new issues on here for things similar to this with problems with the zigbee2mqtt network. |
Having said that, we have to accept that not everything works in a stable manner if we don't use an adapter from the "Recommended" section (which is my case with the SkyConnect): |
An update on this but not 100% sure where the problem was as i have updated z2m a couple of times since this post and also replaced the Sonoff dongle E with a lan connected smlight slzb06 ( I got the M experimental version by mistake but it seems ok). |
Personally, I think my issues stemmed from the Lixee device whose adventures are recounted here: |
What happened?
Map takes a looong time to load and most of the times does not finish loading at all.
I have only 43 devices.
Using HASS with Z2M and a Sonoff Zig USB adapter.
All updated.
Tryed many solutions, removed power reporting from most devices to "uncllog" the network but it does not appear to work much.
Tried cleaning the USB contacts also.
Can you help?
Thanks
Paulo.
What did you expect to happen?
The map to show up correctly and in a short time.
How to reproduce it (minimal and precise)
Start Z2M, go to the admin and request Map do load...
Zigbee2MQTT version
1.28.0 commit: unknown
Adapter firmware version
20220219
Adapter
SONOFF Zigbee 3.0
Debug log
log.txt
The text was updated successfully, but these errors were encountered: