forked from silvanmelchior/RPi_Cam_Web_Interface
-
Notifications
You must be signed in to change notification settings - Fork 0
/
installreadme.txt
30 lines (24 loc) · 1.53 KB
/
installreadme.txt
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
The normal way of installing is to run ./RPi_Cam_Web_Interface_Installer.sh
This remains the case.
There are now some experimental scripts, which have not been fully proven and are still being developed,
but you are welcome to try out.
The main install seems to work for me on Jessie. Not tried on Wheezy yet but in principle it should work.
The scripts are a re-factoring of the install scripts to simplify the process.
5 scripts are used instead of combining all together.
This avoids the overhead of a separate selection and makes it easier to run a particular function automatically.
So start and stop can just be run as separate activities.
The scripts are
install.sh main installation
upgrade.sh check for updates and then run main installation
start.sh starts the software
stop.sh stops the software
remove.sh removes the software
The main installation always does the same thing to simplify its logic.
It gathers all user parameters first in one combined dialog and then always
applies the parameters as it goes through the process.
A q (quiet) parameter may be used to skip this and give an automatic install based on config.txt
All parameters are always in the config.txt file, a default version is created if one
doesn't exist and is then changed just once after the initial user dialog.
The installation always tries to upgrade the main software components and then functionally goes through
the configuration steps for each area like apache, motion start up.
Debug is turned on for th emoment so it logs its activity to a file called install.txt