You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Your program doesnt recognize any filament outage during printing (filament icons shows present) unless i manualy press cancel print, then it shows the filament missing.
So during printing your program doesnt work anyhow.
Thats sad as it was so far the only one tested which recognized my sensor at all.
The text was updated successfully, but these errors were encountered:
OK now it work after total reiinstallation of my raspi including octopi !
It would be nice if you can add the detection-delay to be configured.
It seams that every 60seconds you are checking the pin. which is far too long.
Ok your tool is not working ! During real print when i cut the filament and let the sensor trigger it is not recognizing the missing filament. After i canceled the print it is recognizing and showing not filament found. This is worthless.
Any idea why your tool is just working when you are not printing ?
After installing other plugins the whole octopi installation was dead again, as after restart the whole raspi hangup after reboot (removing sensor pin) worked short but i could not ssh into the pi to get the logfile. now reinstalling again.
i installed floating nav bar, dashboard and mesh bed plugin which i had before i installed yours.
so there must be a big bug in this plugin on a raspi 3B+
Your program doesnt recognize any filament outage during printing (filament icons shows present) unless i manualy press cancel print, then it shows the filament missing.
So during printing your program doesnt work anyhow.
Thats sad as it was so far the only one tested which recognized my sensor at all.
The text was updated successfully, but these errors were encountered: