Back to the User Interface Reference page
Set NRPs or send any MIDI command for the given MIDI channel. Note: Syntherrupter numerates MIDI channels from 0 to 15. Some programs however numerate them from 1 to 16.
The keypad allows you to modify any of the values in the NRP Editor and the MIDI Command section. A switch to change between hexadecimal and decimal is included.
By hitting Ok the commands are executed. If you want to send only an NRP command or only a MIDI command, you have to enter the "wildcard" values (see below) for the other command.
The NRP Editor allows you to quickly set any Non-Registered Parameter. Instead of using MIDI control change commands for all 4 parameters, you can directly enter the values for the NRP number and data entry.
If you do not want to change all of the 4 parameters, you can use the value 0x80 for those that shall remain unmodified. This can be done for all of the values to not send any NRP command at all.
This section allows you to send any 2 or 3-byte MIDI command (no SysEx or realtime messages). If you want to send a command that consists of only 2 bytes (f.ex. MIDI Program Change), use Data 2. Data 1 will be ignored.
If you do not want to send a MIDI command at all, set the status to 0.
The Previous (Next) button brings you to the previous (next) channel. This allows you to quickly navigate through multiple channels without leaving the page.
Leaving the page brings you back to the MIDI Coil Settings.
The changes on this page are channel specific and done via NRP commands. Thus there are no sysex commands needed/available.