This example compiles the WINC STA Bypass application.
This example implements a simple STA Client application on the SAM E54 Xplained Pro board with the ATWINC1500/3400 XPRO board where the WINC controller is in Bypass/Ethernet mode.
To download or clone this application from Github, go to the top level of the repository
Path of the application within the repository is apps/wifi_winc_sta_bypass/firmware .
To build the application, refer to the following table and open the project using its IDE.
Project Name | Description |
---|---|
sam_e54_xpro_winc1500.X | MPLABX project for SAME54 and WINC1500 Xplained pro |
-
Connect the ATWINCxx00 Xpro Wi-Fi board to EXT1 XPRO Header of SAME54 Xplained baord.
-
Connect the Debug USB port on the SAME54 Xplained Pro board to the computer using a micro USB cable
-
Open the project in MPLAB® X IDE and open the app.c file to change the access point parameters as shown in the picture below.
-
Build and program the generated code into the hardware using its IDE by using on-board EDBG programmer.
-
Open a terminal application (eg: TeraTerm) and configure the baud rate for 115200.
-
Press the Reset button on the SAM E54 Xplained Ultra board.
-
The following messages will be visible on the terminal window.
-
Type ping <PC's IP address> in the terminal window and press Enter to see responses.
-
You can also ping this board from your PC using cmd prompt as shown below.
Following Wireless Wiki tutorial shows step-by-step process to create this project from scratch