permalink | sidebar | keywords | summary |
---|---|---|---|
config-windows/fc-perform-specific-task.html |
sidebar |
Fibre Channel protocol, switches, zone switches, zoning, host port identifiers, express Windows configuration, software configuration, Windows host, E2800, E5700, EF300, EF600, E-Series, eseries |
For the Fibre Channel protocol, you configure the switches and determine the host port identifiers. |
For the Fibre Channel protocol, you configure the switches and determine the host port identifiers.
Configuring (zoning) the Fibre Channel (FC) switches enables the hosts to connect to the storage array and limits the number of paths. You zone the switches using the management interface for the switches.
Make sure you have the following:
-
Administrator credentials for the switches.
-
The WWPN of each host initiator port and of each controller target port connected to the switch. (Use your HBA utility for discovery.)
You must zone by WWPN, not by physical port. Each initiator port must be in a separate zone with all of its corresponding target ports. For details about zoning your switches, see the switch vendor’s documentation.
-
Log in to the FC switch administration program, and then select the zoning configuration option.
-
Create a new zone that includes the first host initiator port and that also includes all of the target ports that connect to the same FC switch as the initiator.
-
Create additional zones for each FC host initiator port in the switch.
-
Save the zones, and then activate the new zoning configuration.
You install an FC HBA utility so you can view the worldwide port name (WWPN) of each host port. Additionally, you can use the HBA utility to change any settings recommended in the Notes column of the NetApp Interoperability Matrix Tool for the supported configuration.
Review these guidelines for HBA utilities:
-
Most HBA vendors offer an HBA utility. You will need the correct version of HBA for your host operating system and CPU. Examples of FC HBA utilities include:
-
Emulex OneCommand Manager for Emulex HBAs
-
QLogic QConverge Console for QLogic HBAs
-
-
Download the appropriate utility from your HBA vendor’s web site.
-
Install the utility.
-
Select the appropriate settings in the HBA utility.
Appropriate settings for your configuration are listed in the Notes column of the NetApp Interoperability Matrix Tool.
You can generate and print a PDF of this page, and then use the following worksheet to record FC storage configuration information. You need this information to perform provisioning tasks.
The illustration shows a host connected to an E-Series storage array in two zones. One zone is indicated by the blue line; the other zone is indicated by the red line. Any single port has two paths to the storage (one to each controller).
Callout No. | Host (initiator) port connections | WWPN |
---|---|---|
1 |
Host |
not applicable |
2 |
Host port 0 to FC switch zone 0 |
|
7 |
Host port 1 to FC switch zone 1 |
Callout No. | Array controller (target) port connections | WWPN |
---|---|---|
3 |
Switch |
not applicable |
6 |
Array controller (target) |
not applicable |
5 |
Controller A, port 1 to FC switch 1 |
|
9 |
Controller A, port 2 to FC switch 2 |
|
4 |
Controller B, port 1 to FC switch 1 |
|
8 |
Controller B, port 2 to FC switch 2 |