You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
When attaching a part, the roll parameter of the second connector is ignored. This is an intentional design choice, as the code is commented with "The rolling angle of the attachable part is not used".
While it doesn't provide any additional capability to use this angle, it's confusing that it's ignored. Is there some reason to ignore it?
The text was updated successfully, but these errors were encountered:
When attaching a part, the roll parameter of the second connector is ignored. This is an intentional design choice, as the code is commented with "The rolling angle of the attachable part is not used".
While it doesn't provide any additional capability to use this angle, it's confusing that it's ignored. Is there some reason to ignore it?
The text was updated successfully, but these errors were encountered: