You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I have an issue where the Z moves in my end of print g-code are being picked up by either the plugin or octoprint itself. This z move is being added to the total height, so a model that is 20mm tall will show as 32mm total height (a z-move of 02. and 10).
I've seen this issue mentioned a couple of times but was a few years back where there were still options for the height settings which have since been removed.
Are there any work-arounds' or any plans to stop analyzing the file after and before certain points, or adding an option for manually offsetting the total height? Thanks
The text was updated successfully, but these errors were encountered:
I have an issue where the Z moves in my end of print g-code are being picked up by either the plugin or octoprint itself. This z move is being added to the total height, so a model that is 20mm tall will show as 32mm total height (a z-move of 02. and 10).
I've seen this issue mentioned a couple of times but was a few years back where there were still options for the height settings which have since been removed.
Are there any work-arounds' or any plans to stop analyzing the file after and before certain points, or adding an option for manually offsetting the total height? Thanks
The text was updated successfully, but these errors were encountered: