RfRAW 177 or RfRAW AAB155 cmd using fixed

[supertobi265]

Hello everyone.
I am new here. I am using a RF- Bridge with portisch firmware for decoding a Dooya 1602. That works very well, but my problem is, that the RfRAW mode is not switched on for everytime. Sometimes it works 10 minutes or 10 hours and when I switched off the power from the bridge is the RfRAW mode also switched off. I hope evereryone have good idea.

Greatings from Magdeburg Germany

[marceltech]

hello I stuck on the same, did you get it solved?

[aymeric106]

Hi, I think it is expected on reboot

RfRaw	This command only works when the firmware has been updated with Portisch firmware. Refer to the Portisch wiki for details.Learning and Decoding RF Codes with Portisch Firmware0 = Set iTead default firmware support and messages (default on restart)

You can add a rule to trigger on boot ( trigger -> System#Boot)
and perhaps like this trigger RfRaw#Data=OFF

Aymeric

[aymeric106]

perhaps this also

arendst/Tasmota#7064

[vampywiz17]

@marceltech @supertobi265

Old .hex solve this?