Skip to content

Latest commit

 

History

History
39 lines (33 loc) · 1.68 KB

WIFI_ANDROID.md

File metadata and controls

39 lines (33 loc) · 1.68 KB
Raw

Commissioning Wifi Device using Android

Commissioning can be done using an Android Phone through the following steps.

Download pre-build application from the Matter Artifacts page.

  1. Open the .apk that is installed in the Android mobile
  2. Connect the Android phone to the Wi-Fi Access Point that is going to be used
  3. Run the installed CHIP app
  4. Click 'Provision Chip device with Wi-Fi'
  5. The app will bring up the camera:
    • Hold the camera to the LCD on the WSTK board
    • Scan the QR Code displayed on LCD screen of EFR32 MG12 Platform
  6. Input the SSID/Passphrase of the Wi-Fi Access Point on the next screen
  7. You will see messages (Toasts) pop up - saying that the App is 'Scanning', then 'Pairing', followed by 'Commissioning Done'
  8. Once commissioning is completed, the app will go back to the original/home screen
  9. Click on 'Light ON/OFF & Level Cluster'
  10. You can then bring up the On/Off Cluster and send On/Off Commands (Toggle does not work as required currently) - this will cause LED 1 on the WSTK to change states

If the Commissioning is not successful, try to re-boot your mobile and try again.

Once commissioning is completed, if you want to repeat the test, follow these steps:

  • Remove power to the system (EFR32MG12 + RS9116)
  • Power up the system again - this should cause the LCD to turn on and the QR code to show up
  • Press the BTN0 button and keep it pressed for about 1 min - this should cause LED0 and LED1 to turns ON and OFF for 3 times. You can then release the button

Table of Contents | Thread Demo | Wi-Fi Demo