Upgrades: Extruder CHC
Individual notes Extruder Would need to run the cable to the mainboard through the loom Ideally would want to do the extruder and CHC in one go
[extruder] #max_extrude_cross_section: 16 ; Threw an error, might delete max_extrude_only_distance: 100 step_pin: PB3 dir_pin: !PB4 enable_pin: !PD1 microsteps:16 full_steps_per_rotation: 200 ; Orbiter #rotation_distance: 21.36 ; BMG rotation_distance: 4.637 ; Orbiter 2.0 pressure_advance: 0.089 ; PLA+ #gear_ratio: 50:17 ; BMG ratio nozzle_diameter: 0.400 filament_diameter: 1.750 heater_pin: PC8 #sensor_type: EPCOS 100K B57560G104F ; old stock heater #sensor_type: ATC Semitec 104GT-2 ; Stock V6 all-metal hotend sensor_type: ATC Semitec 104NT-4-R025H42G ; CHC hotend sensor_pin: PA0 min_temp: 0 max_temp: 250 min_extrude_temp: 180
[tmc2209 extruder] uart_pin: PC11 tx_pin: PC10 uart_address: 3 run_current: 0.80 ; guide suggests 0.85 but starting lower hold_current: 0.100 ; From guide sense_resistor: 0.11 stealthchop_threshold: 0 driver_TBL: 0 driver_HEND: 6 driver_HSTRT: 7 driver_TOFF: 4
ORIGINAL STEPPER DEETS
[extruder] #max_extrude_cross_section: 16 ; Threw an error, might delete max_extrude_only_distance: 100 step_pin: PB3 dir_pin: !PB4 enable_pin: !PD1 microsteps:16 rotation_distance: 21.36 pressure_advance: 0.089 ; PLA+ gear_ratio: 50:17 ; BMG ratio nozzle_diameter: 0.400 filament_diameter: 1.750 heater_pin: PC8 #sensor_type: EPCOS 100K B57560G104F ; old stock heater sensor_type: ATC Semitec 104GT-2 sensor_pin: PA0 min_temp: 0 max_temp: 250 min_extrude_temp: 180
[tmc2209 extruder] uart_pin: PC11 tx_pin: PC10 uart_address: 3 run_current: 0.580 ; for safety hold_current: 0.25 ; 50% of run stealthchop_threshold: 0