Replies: 3 comments
-
Hi, |
Beta Was this translation helpful? Give feedback.
-
I think this idea should be considered, since it's much better than the tower currently offered in Orca See how easily the best speed/distance combination can be visually identified |
Beta Was this translation helpful? Give feedback.
-
I like the box, but it takes a while to print, and is very hard to setup correctly, and when it fails, it fails spectacularly. Some automation is needed in the setup/config, but it is one of the best combo tests... |
Beta Was this translation helpful? Give feedback.
-
Hello,
I always used the retract test from http://www.retractioncalibration.com/
See additional hints at: https://www.cnx-software.com/2020/07/08/3d-printer-retraction-calibration-vol-ii-calibration-generator-program-release/
Especially in the comments.
Unfortunately I can't get it to work for my Bambu X1C.
But this retract test is just great. Maybe you can contact the developer and include the tool? Then you could also offer this via the calibration.
Contact person is probably: Karl Johnson
https://www.cnx-software.com/author/test_writer/
Beta Was this translation helpful? Give feedback.
All reactions