Lilygo 7000g gps not working

[git-tiger]

I have the 7000g version, and tested the gpstest. Power to the antenna is working via the AT command.
Just that no lat/long data is shown.
Could it be the antenna is broken?

[DevinCarpenter]

Possible but unlikely. I have quite a few of these units and every single one has worked great. What is the output you are getting?

Just so you know - This thing can take a while to connect. Being on the ground floor in a big building could prevent you from getting signal from the satellites....That caused problems for me. But being indoors in most places hasn't been an issue.

'+CGNSINF: 1,0,,,,,,,0,,,,,,4,,,,46,,' This is an example output of trying to get signal. I believe '46' is the number of GNSS satellites in range for location triangulation - though don't quote me.

This is along the lines of what you will get from the CGNSINF command when it connects.
'+CGNSINF: 1,1,20230126203118.000,38.897629,-77.036780,17.600,0.00,0.0,1,,1.0,1.3,0.9,,24,5,3,,43,,'

Please be aware that the GPS actually has a cold start and a hot start as well. Cold start could take a while. For me it's about 20 seconds to 10 minutes - at which point I just reset the modem. Hot start could take less than 5 seconds. So connecting after you've already connected shortly before will always yield the fastest results.

[git-tiger]

I got this to work now. Thanks to @DevinCarpenter
Used AT command: AT+CGNSHOR=10 and now it is able to get the location.

[DevinCarpenter]

Glad to hear it. For future reference the comment detailing the commands I use is here