Problems with running

[michalfordonski]

Hi, I like your project. I already have all the necessary elements, but I ran into a few problems.

1. Problem with resetting (I test on the table, I commented on connecting to the ECU) - Log:

16585
------connect addr=23 baud=10400
---KWP 5 baud init
bit0=0 startbit
bit1=1
bit2=1
bit3=1
bit4=0
bit5=1
bit6=0
bit7=0
bit8=1 parity
bit9=1 stopbit
---KWPReceive sz=3 blockCounter=0
IN: sz=3 data=55 1 8A 
------readconnectblocks
---KWPReceive sz=0 blockCounter=1
IN: sz=16 data=F 1 F6 B1 4A 35 39 32 30 38 34 36 41 20 20 3 
---KWPSendAckBlock blockCounter=2
---KWPSend sz=4 blockCounter=2
OUT:3 2 9 3 
---KWPReceive sz=0 blockCounter=3
IN: sz=16 data=F 3 F6 4B 4F 4D 42 49 2B 57 45 47 46 41 48 3 
---KWPSendAckBlock blockCounter=4
---KWPSend sz=4 blockCounter=4
OUT:3 4 9 3 
---KWPReceive sz=0 blockCounter=5
IN: sz=15 data=E 5 F6 52 53 50 20 56 44 4F 20 56 32 30 3 
---KWPSendAckBlock blockCounter=6
---KWPSend sz=4 blockCounter=6
OUT:3 6 9 3 
---KWPReceive sz=0 blockCounter=7
IN: sz=9 data=8 7 F6 0 81 DE 75 3B 3 
---KWPSendAckBlock blockCounter=8
---KWPSend sz=4 blockCounter=8
OUT:3 8 9 3 
---KWPReceive sz=0 blockCounter=9
IN: sz=4 data=3 9 9 3 
label=�J5920846A KOMBI+WEGFARSP VDO V2
Disabled.  Force pins HIGH
Return & Display Boot Message

The effect is that every now and then there is Welcome Adam!, Connecting to cluster 1/3, and reset (message from cluster: Immo. Activated) and so on in the loop

2. Could you write more about connecting the buttons (Pins 4,5,6) and the ignition (pin 7)? I.e. more specifically, what voltage should go to the pins - 12v, 5v, ground?