You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Whenever I set the bed-temp for "First Layer" and "Other Layer" to 0, it is ignored by slic3r and reset to the value before (60) after reloading. It even writes the wait-command to the GCODE-File.
My Version is 0.9.9 but is has been in 0.9.8, too, and mayber the Version before also. Just forgot to issue it here. ;)
The text was updated successfully, but these errors were encountered:
I am seeing this too. Looks like it is related to 1094 (Fillament Temperature Settings Revert on Save)
If I set the heat bed values to 0 then save, they revert to 60. If I set them to 1 and save, it saves ok and I can then set them to 0 and save without issue. From then on (at least so far) I can set the temperatures to 60 and back to 0 without issue.
Looks like it will update if you set it to a non zero value other than the one already shown. i.e. if the bed temperature is 60, setting it to 61 will update and you can then set it to 0.
Whenever I set the bed-temp for "First Layer" and "Other Layer" to 0, it is ignored by slic3r and reset to the value before (60) after reloading. It even writes the wait-command to the GCODE-File.
My Version is 0.9.9 but is has been in 0.9.8, too, and mayber the Version before also. Just forgot to issue it here. ;)
The text was updated successfully, but these errors were encountered: