A Little Help with simple 4 button Midi Controller

[Celticpure]

HI everyone.

I am struggling a bit with setting up a simple four button midi controller footswitch for my Boss Katana amp through the Katana Librarian app for android.

I have wiring completed and file system built and uploaded successfully and the device is running and connected to my WIFI network etc. So on this front I feel I have everything covered. It is the execution of the command setup that I am struggling with.

I have 4 patches that I can assign and access through ControlChange commands via the four designated button/switches on my footswitch, However I want to use the a long button press (or similar command) to access the effects on on the Katana librarian app - i.e. Booster/Delay/Reverb and the three sub-setting on each with the same 4 buttons being also used for patch selection.

Any help on how to go about this would be most welcome... photo below shows the footswitch.

[alf45tar]

@Celticpure did you used momentary or latch switches?
Long Press cannot be used with latches for physical reason.

Assuming you configured pedals from 1 to 4, I can provide you with a configuration file as example.

[Celticpure]

I am using momentary, yes I have configured my installation for pedals 1-4 in the pedals.h file.

Thank you that would be great. 👍

[alf45tar]

Unzip it before upload to PedalinoMini

celticpure.cfg.zip

[Celticpure]

Thank you very much. I will try this tomorrow. 👍

[Celticpure]

Thank you @alf45tar for the config file. I am unsure what the only option of 'OSC Message' is for? This is the only option I can select from the 'ON' drop down menu. I have attached a screenshot below.

[Celticpure]

Did you imported Controls?
The configuration is for version 3. You are using version 2.

Yes I am using version 2.5.2. Did not import the file in the MACOSX folder as I assume it for Mac OS etc. I am on windows. Below are the files in the zip you attached. Thank you.

[alf45tar]

Use the file celticpure.cfg outside _MACOSX folder. It is 3.83 kb in size.

[Celticpure]

Use the file celticpure.cfg outside _MACOSX folder. It is 3.83 kb in size.

Yes, that is the file I used. The only options I have is as shown in my screenshot above.

[alf45tar]

Here attached the file for version 2

celticpure2.cfg.zip

[Celticpure]

Just a few photos of my midi pedal for Katana Librarian. Getting grips with Pedalino, a great project and very worthwhile sponsoring!!

IMG_20221130_161158.jpg

[rigr]

Nice!