New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
reverting changes #34
Comments
Hello.
Sorry, didn't get time to look at your question before this week-end.
I just updated the documentation to add a section concerning the
recovery.
https://github.com/amouiche/qnap_mtd_resize_for_bullseye/blob/master/Recovery.md
Please, can you see if you have sufficient details for your purpose ?
Regards,
Arnaud
…On Wed, 2022-11-09 at 02:52 -0800, Bartosz Fenski wrote:
I used this script to change partition layout on my TS-421 but now I
decided to sell it so I'd like to install QTS on it.
I was able to do that using recovery via tftp and it went fine.
However updating to newer firmware fails and I believe this is due to
changed partition layout. So the question is how to revert it safely?
I have backup of mdt files before I run your script.
—
Reply to this email directly, view it on GitHub, or unsubscribe.
You are receiving this because you are subscribed to this
thread.Message ID:
***@***.***>
|
Nice work! Note, the document linked above seems incomplete. The last phrase seems incomplete, please check. |
@amouiche thank a lot! |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
I used this script to change partition layout on my TS-421 but now I decided to sell it so I'd like to install QTS on it.
I was able to do that using recovery via tftp and it went fine. However updating to newer firmware fails and I believe this is due to changed partition layout. So the question is how to revert it safely?
I have backup of mdt files before I run your script.
The text was updated successfully, but these errors were encountered: