You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Did you check that your request is not a duplicate?
Yes, I have checked and this is a new request.
Is your request specific to your setup only or can it benefit to many people?
My request will benefit to many people.
Is your feature request related to a problem? Please describe.
No response
Describe the feature you want
Each time the printer is started, the temperature for loading/unloading filament is reset to its hard-coded value (200). It would be better to instead save it into EEPROM and restore it on boot.
Did you check that your request is not a duplicate?
Yes, I have checked and this is a new request.
Is your request specific to your setup only or can it benefit to many people?
My request will benefit to many people.
Is your feature request related to a problem? Please describe.
No response
Describe the feature you want
Each time the printer is started, the temperature for loading/unloading filament is reset to its hard-coded value (200). It would be better to instead save it into EEPROM and restore it on boot.
Additional context
https://community.advi3pp.com/t/can-the-default-temperature-to-load-unload-filament-be-changed-in-firmware/4556/2
Have you provided enough and precise information?
Yes, I have provided precise information in the Additional context box.
The text was updated successfully, but these errors were encountered: