Image URL entry issues

[tomashora]

1. Tried to enter the URL via Bit.ly shortener (because typing the whole URL would take a lot of time), a dialog “Error opening source” appeared but without any visible error– when I clicked on the cross in top right corner the dialog closed but keyboard did not hide so I ended up at power cycling the EtcherPro

2. After opening the Image URL again and trying the same URL, the error occurred but only then I could see the error “certificate expired” (now it was not covered by the keyboard), when clicked OK, got again to the point where the EtcherPro did not respond to any click/touch