You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
The hexagon socket head screw creator creates incorrect length for all lengths shorter than 21mm.
Creating an M3x21mm is correct.
M3X20 gives length of 18mm and all sizes down is 18mm long. The same applies to other sizes.
I have checked this for ISO, ANSI and DIN.
I have used BOLTSFC with V0.16 Rev 6712. as well as the bleeding edge V0.17 Rev13125.
The text was updated successfully, but these errors were encountered:
The hexagon socket head screw creator creates incorrect length for all lengths shorter than 21mm.
Creating an M3x21mm is correct.
M3X20 gives length of 18mm and all sizes down is 18mm long. The same applies to other sizes.
I have checked this for ISO, ANSI and DIN.
I have used BOLTSFC with V0.16 Rev 6712. as well as the bleeding edge V0.17 Rev13125.
The text was updated successfully, but these errors were encountered: