-
USB + power
- Glue 2.1x5.5mm barrel jack to underside left
- Route +5 from barrel to TP2
- Route GND from barrel to I2S GND
-
Composite, #1
- Cut trace from composite pin 1 (shield / GND) to C20
- Route from composite pin 2 (signal) to C20
- Add GND from composite pin 1 to VGA shield GND
-
USER1 conflicts with SPI4_CK/PE2 (which can't be disabled through MX - can it work if disabled by hand?)
- Cut USER1 trace to PE2
- Route to TIM3_CH2 / PB5 (MOUSE CLK)
-
Add 21.47277MHz to TIM1_CH3/PA10 (or TIM1_CH1/PA8 if PA10 not possible) for TMS9918A clock
-
Cut PA10/USART1_RX before R46 and join with USART1_TX
-
Glue part near PA10
-
Route CLK to PA10/pin121
-
Route to PA8 / USART1_CK (on current board)
-
Route GND and +3.3V
-
HAL_TIM_IC_Stop(&htim1, TIM_CHANNEL_1); status = HAL_TIM_IC_Start(&htim1, TIM_CHANNEL_3); to sync to 21.47MHz
-