You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
after a few days of tracing code in octoprint..... While running bufferbuddy octoprint finishes the print to early.
Depending on the buffersize config this will be more or less obvious, but mine are large enough that i have around 100 moves 'left' when the final m400 is send by octoprint.
because octoprint doesn't wait for all the buffers to drain on this point the printer is happily printing the finals lines while octoprint thinks the printer is finished.
tested this theory by adding 100 times M400 add the end of the file to make sure the buffer is completely filled with NO-OP's and then the timelapse is just fine.
i don't expect that this plugin can fix this, but it might be usefull to document it as knows issue with workaround
The text was updated successfully, but these errors were encountered:
Hello,
after a few days of tracing code in octoprint..... While running bufferbuddy octoprint finishes the print to early.
Depending on the buffersize config this will be more or less obvious, but mine are large enough that i have around 100 moves 'left' when the final
m400
is send by octoprint.because octoprint doesn't wait for all the buffers to drain on this point the printer is happily printing the finals lines while octoprint thinks the printer is finished.
tested this theory by adding 100 times
M400
add the end of the file to make sure the buffer is completely filled with NO-OP's and then the timelapse is just fine.i don't expect that this plugin can fix this, but it might be usefull to document it as knows issue with workaround
The text was updated successfully, but these errors were encountered: