/
IRrecvDemo.ino
56 lines (50 loc) · 1.88 KB
/
IRrecvDemo.ino
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
/*
* IRremoteESP8266: IRrecvDemo - demonstrates receiving IR codes with IRrecv
* This is very simple teaching code to show you how to use the library.
* If you are trying to decode your Infra-Red remote(s) for later replay,
* use the IRrecvDumpV2.ino (or later) example code instead of this.
* An IR detector/demodulator must be connected to the input kRecvPin.
* Copyright 2009 Ken Shirriff, http://arcfn.com
* Example circuit diagram:
* https://github.com/crankyoldgit/IRremoteESP8266/wiki#ir-receiving
* Changes:
* Version 0.2 June, 2017
* Changed GPIO pin to the same as other examples.
* Used our own method for printing a uint64_t.
* Changed the baud rate to 115200.
* Version 0.1 Sept, 2015
* Based on Ken Shirriff's IrsendDemo Version 0.1 July, 2009
*/
#include <Arduino.h>
#include <IRremoteESP8266.h>
#include <IRrecv.h>
#include <IRutils.h>
// An IR detector/demodulator is connected to GPIO pin 14(D5 on a NodeMCU
// board).
// Note: GPIO 16 won't work on the ESP8266 as it does not have interrupts.
// Note: GPIO 14 won't work on the ESP32-C3 as it causes the board to reboot.
#ifdef ARDUINO_ESP32C3_DEV
const uint16_t kRecvPin = 10; // 14 on a ESP32-C3 causes a boot loop.
#else // ARDUINO_ESP32C3_DEV
const uint16_t kRecvPin = 14;
#endif // ARDUINO_ESP32C3_DEV
IRrecv irrecv(kRecvPin);
decode_results results;
void setup() {
Serial.begin(115200);
irrecv.enableIRIn(); // Start the receiver
while (!Serial) // Wait for the serial connection to be establised.
delay(50);
Serial.println();
Serial.print("IRrecvDemo is now running and waiting for IR message on Pin ");
Serial.println(kRecvPin);
}
void loop() {
if (irrecv.decode(&results)) {
// print() & println() can't handle printing long longs. (uint64_t)
serialPrintUint64(results.value, HEX);
Serial.println("");
irrecv.resume(); // Receive the next value
}
delay(100);
}