You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
IMPORTANT: This section is meant for bug reporting only. For usage issues, please go to the Support Forums.
Describe the bug
When setting up the hydraulic profile for a pipe line, an error message comes saying error in the segment. this only happens when adding anything else as the segment 2. if I add another straight line this doesn't happen
To Reproduce
PLEASE ATTACH THE ZIPPED FLOWSHEET FILE and/or inform the steps to reproduce the behavior:
Select "new chemical process model ", select peng robinson and water and in SI(engineering units )
Set up, pipe through a pump and another pipe
Select the line fist put a flow of 6m3/h
4.once that is done, select the pipe next
In the pipe hydraulic add a straight pipe(PVC. Length 1.3,elevation 0, external diameter 63 adn internal diameter 58.2 (mm)
press the green tick and then the green +
select an elbow 90dg (PVC) and internal diameter 58.2
select the green tick again
error comes up
Expected behaviour
I expect the status to be green and I should be able to move on to adding another segment
Screenshots
If applicable, add screenshots to help explain your problem.
Desktop (please complete the following information):
Windows 10 Pro
Version 22H2
Additional context
Add any other context about the problem here.
The text was updated successfully, but these errors were encountered:
IMPORTANT: This section is meant for bug reporting only. For usage issues, please go to the Support Forums.
Describe the bug
When setting up the hydraulic profile for a pipe line, an error message comes saying error in the segment. this only happens when adding anything else as the segment 2. if I add another straight line this doesn't happen
To Reproduce
PLEASE ATTACH THE ZIPPED FLOWSHEET FILE and/or inform the steps to reproduce the behavior:
4.once that is done, select the pipe next
Expected behaviour
I expect the status to be green and I should be able to move on to adding another segment
Screenshots
If applicable, add screenshots to help explain your problem.
Desktop (please complete the following information):
Additional context
Add any other context about the problem here.
The text was updated successfully, but these errors were encountered: