3.2

• Add a blue print graphic to show the shape of the frame parts.
• Update cutouts and strengthen weak points around second and third row standoffs on top and bottom plate.
• Add 20x20 M2 stack mount option to the rear of the bottom plate. Fits Caddx Vista unit.
• Remove the cam plates and add a slim TPU mount for micro/mini/DJI size cameras.
• Update build recommendations, new recommended standoff height is 25mm.
• The carbon is overall 1g heavier due to smaller cutouts.

Side view

3.1

• Added a GPS mount for the rear for 18x18mm boards
• Removed the little diamond cut outs on the arms as they were too small for getting proper results when cutting and making them larger would weaken the arms
• Updated the top and bottom plate cut outs pattern to make it more harmonic and leave a bit more room for the camera plate cut outs.
• Updated hero rendering

Side view

3.0

• Shortened the arms a bit further to a motor to motor distance of 225mm (length not needed anymore because the option to strap on an action cam was removed)
• Shortened the front and rear section by 2 and 1mm (it was possible without drawbacks due to shorter arms)
• Added a cam plate to fit and carry micro size cameras
• Added countersunk screw indicators
• Added a camera case for the Hero 6/7 mount (3D print accessory)
• Added a camera mount adapter (3D print accessory)

2.1

• Decided to switch from 240mm to 230mm motor to motor distance and strengthen the arms with the weight saved (a trade-off between stability and agility, making it a better all-rounder)
• Arms are a little thicker to improve a potential break point
• Reduced frame weight by 2,5g due to arms getting shorter

Front view

Side view

2.0

• New arm design with a better predetermined break point
• New arm position and the center section therefore can be more narrow
• Arms are interlocking in the middle now which makes the frame way stiffer
• Smaller cam plate and improved mounting for Mini size cameras
• Added separate cam plates for Runcam and Foxeer mounting pattern
• Cam plate and thus frame height now 28mm instead of 30mm
• Moved the middle standoffs slightly to the front/back
• Center plate is now a real center plate again so the motors move up by 2mm
• Slightly wider rear section, not converging anymore, for better battery placement
• The top plate now leaves enough space to prepare the four rear holes for counter sunk screws

1.1

• Arm geometry slightly more squeezed, Pythagorean triple 3:4:5, less props in view on lower tilt.
• Reinforced 2mm wider front section.
• Cam plate now with mounting holes for micro and mini fpv cams.

1.0

Initial release with reinforced rigidity of the center section and arm mounting after a first carbon prototype.