Skip to content

Latest commit

 

History

History
27 lines (22 loc) · 2.23 KB

circle.md

File metadata and controls

27 lines (22 loc) · 2.23 KB

<MapView.Circle /> Component API

Props

Prop Type Default Note
center LatLng (Required) The coordinate of the center of the circle
radius Number (Required) The radius of the circle to be drawn (in meters)
strokeWidth Number 1 The stroke width to use for the path.
strokeColor String #000 The stroke color to use for the path.
fillColor String The fill color to use for the path.
lineCap String round The line cap style to apply to the open ends of the path.
lineJoin Array<LatLng> The line join style to apply to corners of the path.
miterLimit Number The limiting value that helps avoid spikes at junctions between connected line segments. The miter limit helps you avoid spikes in paths that use the miter lineJoin style. If the ratio of the miter length—that is, the diagonal length of the miter join—to the line thickness exceeds the miter limit, the joint is converted to a bevel join. The default miter limit is 10, which results in the conversion of miters whose angle at the joint is less than 11 degrees.
geodesic Boolean Boolean to indicate whether to draw each segment of the line as a geodesic as opposed to straight lines on the Mercator projection. A geodesic is the shortest path between two points on the Earth's surface. The geodesic curve is constructed assuming the Earth is a sphere.
lineDashPhase Number 0 (iOS only) The offset (in points) at which to start drawing the dash pattern. Use this property to start drawing a dashed line partway through a segment or gap. For example, a phase value of 6 for the patter 5-2-3-2 would cause drawing to begin in the middle of the first gap.
lineDashPattern Array<Number> null (iOS only) An array of numbers specifying the dash pattern to use for the path. The array contains one or more numbers that indicate the lengths (measured in points) of the line segments and gaps in the pattern. The values in the array alternate, starting with the first line segment length, followed by the first gap length, followed by the second line segment length, and so on.

Types

type LatLng {
  latitude: Number,
  longitude: Number,
}