/
mod.transfer
43 lines (25 loc) · 1.13 KB
/
mod.transfer
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
Last revised: January 1, 2002
TRANSFER MODULE
The transfer module provides DCC SEND/GET support and userfile transfer
support for userfile sharing.
This module requires: none
Put this line into your Eggdrop configuration file to load the transfer
module:
loadmodule transfer
There are also some variables you can set in your config file:
set max-dloads 3
Set here the maximum number of simultaneous downloads to allow for
each user.
set dcc-block 0
Set here the block size for dcc transfers. ircII uses 512 bytes,
but admits that may be too small. 1024 is standard these days. Set
this to 0 to use turbo-dcc (recommended).
set copy-to-tmp 1
Enable this setting if you want to copy files to a temporary location
before sending them. This might be useful for file stability, but if your
directories are NFS mounted, it's a pain. Setting this to 1 is not
advised for big files or if you're low on disk space.
set xfer-timeout 30
Set here the time (in seconds) to wait before an inactive transfer
times out.
Copyright (C) 2000 - 2017 Eggheads Development Team