Enhancement: Trim beeps go solid before end of trim range is reached

[GoogleCodeExporter]

What steps will reproduce the problem?
1. The trim beeping goes to a solid tone before all available trim has been 
used.  This gives a false impression in flight that there is no more trim to be 
had when in fact there is.
2. There is no distinct tone when the center of trim travel is reached.

What is the expected output?  The beeping should continue until all available 
trim travel is used, and then the tone should go solid. A distinct tone should 
be made when trim is at zero trim.


What version of the product are you using? r7


Please provide any additional information below.

Original issue reported on code.google.com by jalowe1234@gmail.com on 12 Aug 2010 at 1:15

[GoogleCodeExporter]

The trim beeps at the ends and in the middle.
I was not able to reproduce a condition where the beep occurred mid-way.

Can you describe your setup and how you see the problem? 

Original comment by erezra...@gmail.com on 12 Aug 2010 at 5:05

[GoogleCodeExporter]

If you press and hold the trim button, the sound goes solid far before it 
reaches the end.  Try this with extrafine trim.  If you hold it as it passes 
through center, there is no distinguishing beep.

Original comment by jalowe1234@gmail.com on 13 Aug 2010 at 3:45

[GoogleCodeExporter]

I see what you mean.   The beeps are so close together that they sound like a 
continuous beep.   I'll add it to the TOFIX list.

Original comment by erezra...@gmail.com on 13 Aug 2010 at 8:40

• Changed state: Accepted

[GoogleCodeExporter]

Original comment by erezra...@gmail.com on 14 Aug 2010 at 12:02

• Changed state: Fixed

[GoogleCodeExporter]

Not fully fixed in r14.  Goes solid before end of range on exfine trim setting. 
 Also goes solid before center is reached.

Original comment by jalowe1234@gmail.com on 14 Aug 2010 at 3:08

[GoogleCodeExporter]

I'll look at it again.

Original comment by erezra...@gmail.com on 14 Aug 2010 at 3:18

• Changed state: Started

[GoogleCodeExporter]

Finally, fixed!

Original comment by erezra...@gmail.com on 19 Aug 2010 at 10:43

• Changed state: Fixed