title | date-published | type | standard |
---|---|---|---|
Arlec PCB89HA Power Board |
2020-01-04 |
plug |
au |
- TOC {:toc}
Pin | Function |
---|---|
GPIO1 | LED (Inverted: true) |
GPIO3 | Button (Inverted: true) |
GPIO04 | Relay 2 |
GPIO05 | Relay 1 |
GPIO12 | Relay 4 |
GPIO13 | Relay 3 |
# Basic Config
substitutions:
device_name: "arlec_PCB89HA_1"
name: "ARLEC PCB89HA"
esphome:
name: ${device_name}
comment: ${name}
platform: ESP8266
board: esp01_1m
wifi:
ssid: 'ssid'
password: 'password'
logger:
# Important! The status LED and button are on the Pins used by UART0
hardware_uart: UART1
api:
password: 'api_password'
ota:
password: 'ota_password'
status_led:
pin:
number: GPIO1
inverted: True
sensor:
- platform: uptime
name: ${name} Uptime
- platform: wifi_signal
name: ${name} Signal
update_interval: 300s
binary_sensor:
- platform: gpio
pin:
number: GPIO3
inverted: True
name: ${name} button
internal: True
on_multi_click:
# Support a single or double click to switch on each relay
- timing:
# Single click
- ON for at most 1s
- OFF for at least 0.5s
then:
- switch.toggle: relay_a
- timing:
# Double click
- ON for at most 1s
- OFF for at most 1s
- ON for at most 1s
- OFF for at least 0.2s
then:
- switch.toggle: relay_b
switch:
- platform: gpio
pin: GPIO05
name: "${name} - A"
id: relay_a
restore_mode: always off
- platform: gpio
pin: GPIO04
name: "${name} - B"
id: relay_b
restore_mode: always off
- platform: gpio
pin: GPIO13
name: "${name} - C"
id: relay_c
restore_mode: always off
- platform: gpio
pin: GPIO12
name: "${name} - D"
id: relay_d
restore_mode: always off