TemperatureFailsafe Low Temp Settings

[jeffmaeder]

At first when adding this plugin I thought it would only protect the case where the temp runs out of control high. To my surprise it actually had protection for low temp set points as well. The failure mode I was experiencing was similar to fakio87, after I started a print at some point the heated bed would stop heating. As a result the print would shrink and detach from the bed and well.....everyone has seen it! It turns out some of the solder joints on the mosfet I was using for the heated bed had become compromised . If this Plugin would start examining the temperatures after the "M117 Printing..." line in the starting gcode it would protect against the temp drifting low during a print. This way you wouldn't have to manually preheat the printer.