ESP32 Oscilloscope Clock using internal DACs, with WiFi ntp sync
Mauro Pintus , Milano 2018/05/25
How to use it: Load this sketch on a ESP32 board using the Arduino IDE 1.8.7 See Andreas Spiess video linked below if you dont know how to... Connect your oscilloscope channels to GPIO25 and GPIO26 of the ESP32 Connect the ground of the oscilloscope to the GND of the ESP32 board Put your Oscilloscope in XY mode Adjust the vertical scale of the used channels to fit the clock
Enjoy Your new Oscilloscope Clock!!! :)
Additional notes: By default this sketch will start from a fix time 10:08:37 everityme you reset the board. To change it, modify the variables h,m,s below.
To synchronize the clock with an NTP server, you have to install the library NTPtimeESP from Andreas Spiess. Then ncomment the line //#define NTP, removing the //. Edit the WiFi credential in place of Your SSID and Your PASS. Check in the serial monitor if it can reach the NTP server. You mignt need to chouse a different pool server for your country.
If you want there is also a special mode that can be enabled uncommenting the line //#define EXCEL, removing the //. In this mode, the sketch will run once and will output on the serial monitor all the coordinates it has generated. You can use this coordinates to draw the clock using the graph function in Excel or LibreOffice This is useful to test anything you want to display on the oscilloscope to verify the actual points that will be generated.
GitHub Repository https://github.com/maurohh/ESP32_OscilloscopeClock
Twitter Page https://twitter.com/PintusMauro
Youtube Channel www.youtube.com/channel/UCZ93JYpVb9rEbg5cbcVG_WA/
Old Web Site www.mauroh.com
Credits: Andreas Spiess https://www.youtube.com/watch?v=DgaKlh081tU
Andreas Spiess NTP Library https://github.com/SensorsIot/NTPtimeESP
My project is based on this one: http://www.dutchtronix.com/ScopeClock.htm
Thank you!!
