Skip to content

Latest commit

 

History

History
100 lines (72 loc) · 2.78 KB

class1.log.md

File metadata and controls

100 lines (72 loc) · 2.78 KB
Raw

Class=509 (0x01FD) - Logging

CLASS1.LOG

Description

Logging functionality.

The log can be used by a device to send logging information to a central or distributed place. To use this functionality

  • Open a log channel with a specific id.

  • Send logging events.

  • Close when no more logging events will be sent on that channel.

The logging message can be a maximum of five byte for each event. If you need more space for logging data, send multiple log events and increase the index (starting at zero) for each event that is part of the logging message. Repeating this process next time you need to send logging data by again starting at index 0 and increasing for every part sent.

For Level II the logging message can use the full payload so a maximum message of 508 bytes can be sent.

The id is something you set that have meaning for you. Typically it can be used as an index for a channel you send log messages on in a system where several subsystems needs to be logged and which log info need to be separated.

Remember that the receiving side also have the originating id (GUID) as an identification from where a logging event originates.

Type=0 (0x00) - General event :id=type0

VSCP_TYPE_LOG_GENERAL

General Event.

Type=1 (0x01) - Log event :id=type1

VSCP_TYPE_LOG_MESSAGE

Message for Log. Several frames have to be sent for a event that take up more then the five bytes which is the maximum for each frame. In this case the zero based index (byte 2) should be increased for each frame.

Byte Description
0 ID for event.
1 Log level for message.
2 Idx for this message.
3-7 (511) Message.

A level II node can use the full 512 byte message body.

Log levels are typically

Byte Description
0 Emergency.
1 Alert.
2 Critical.
3 Error.
4 Warning.
5 Notice.
6 Informational.
7 Debug.
7 Verbose.

but one can use any schema that makes sense (or not).

Type=2 (0x02) - Log Start :id=type2

VSCP_TYPE_LOG_START

Start logging.

Byte Description
0 ID for log.

Type=3 (0x03) - Log Stop :id=type3

VSCP_TYPE_LOG_STOP

Stop logging.

Byte Description
0 ID for log.

Type=4 (0x04) - Log Level :id=type4

VSCP_TYPE_LOG_LEVEL

Set level for logging.

Byte Description
0 ID for log byte 0 Log level.

filename