You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Since I am hoping to use this part in one of my designs, I would like to clarify: Does this screw refer to the Eichhorn Constructor screw(s), or is it meant as an example of a more generic (DIN/ISO) screw?
I understand that the part is not fully documented yet. Just wanted to raise this issue early on. Perhaps this gives an incentive to give this part more thought and more priority... 😄
As a side note, the Eichhorn Constructor screws are not truly M10, I believe. They definitely have a coarser threading (~2.5mm) than the typical norm screws (1.5mm or 1mm), so you can not mix and match nuts and bolts.
The text was updated successfully, but these errors were encountered:
https://trikka.house/parts/043-1/
Since I am hoping to use this part in one of my designs, I would like to clarify: Does this screw refer to the Eichhorn Constructor screw(s), or is it meant as an example of a more generic (DIN/ISO) screw?
I understand that the part is not fully documented yet. Just wanted to raise this issue early on. Perhaps this gives an incentive to give this part more thought and more priority... 😄
As a side note, the Eichhorn Constructor screws are not truly
M10
, I believe. They definitely have a coarser threading (~2.5mm) than the typical norm screws (1.5mm or 1mm), so you can not mix and match nuts and bolts.The text was updated successfully, but these errors were encountered: