Skip to content

Latest commit

 

History

History
74 lines (46 loc) · 2.69 KB

README.MD

File metadata and controls

74 lines (46 loc) · 2.69 KB
Raw

Write to new users

  • This page provides a quick diagnosis of whether the hardware is normal. The firmware in the example table below provides quick testing of the hardware. Please follow the steps below to test

1️⃣ Quickly diagnose hardware

Product Firmware Name
T-Display-S3 ScreenDetection
T-Display-S3 Factory
T-Display-S3-Touch Factory
T-Display-S3-MIDI firmware

ScreenDetection After ScreenDetection is written, open the ArduinoIDE or PlatformIO serial monitor, and then press RST (the button on the side of T-Display-S3). The serial monitor should automatically reconnect and print out the relevant screen information. .If all the information is normal but the screen still does not display, you can determine that the screen is damaged.

Use ESP Download Tool

web_flasher

  • Note that after writing is completed, you need to press RST to reset.

Use Web Flasher

web_flasher

  • Note that after writing is completed, you need to press RST to reset.

Use command line

If system asks about install Developer Tools, do it.

python3 -m pip install --upgrade pip
python3 -m pip install esptool

In order to launch esptool.py, exec directly with this:

python3 -m esptool

For ESP32-S3 use the following command to write

esptool --chip esp32s3  --baud 921600 --before default_reset --after hard_reset write_flash -z --flash_mode dio --flash_freq 80m 0x0 firmware.bin

2️⃣FAQ

  • Can't upload any sketch，Please enter the upload mode manually.
    1. Connect the board via the USB cable
    2. Press and hold the BOOT button , While still pressing the BOOT button (If there is no BOOT button, you need to use wires to connect GND and IO0 together.)
    3. Press RST button
    4. Release the RST button
    5. Release the BOOT button (If there is no BOOT button, disconnect IO0 from GND.)
    6. Upload sketch
    7. Press the RST button to exit download mode