You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
First some info:
Configurator version: 6.0.0
FC Firmware: 6.0.0 [SPEEDYBEEDF405V3]
FC: SpeedyBee F405 V3
ESC: 4in1 SpeedyBee F405 ESC Stack
Receiver: RP3 ExpressLRS
Other:
2x Cameras
Camera Switcher
GPS
VTX (SpeedyBee TX800)
24x WS2812 LEDs
Buzzer
I am in the configurator trying to set the wiring for my LEDs (like I did in version 5.0.0), but it isn't working! I click the "Wire Ordering Mode" button so the background changes to light green, but when I click the squares to set the wiring, nothing happens except for a pink highlight on the one that was clicked.
What is going on here? 🤔. I hope this is a simple issue arising from my incompetence lol.
I also tried setting up everything in the CLI, but that didn't seem to work either. I DO have "feature LED_STRIP" enabled.
Besides that issue, I am not sure how to attach my camera switcher to a RC channel, or even where to attach it on my FC ( I have it wired to S9 right now). I'm not sure where to ask that question though 🤷♂️.
Thanks in advance!
The text was updated successfully, but these errors were encountered:
I saved all of my settings in the CLI by typing "diff all" and saved them to a file. I then re-flashed the same 6.0.0 firmware with "full erase" selected. Then, I went back into the CLI, and added the file, and done!
I am still not sure how to setup my camera switcher; it seems like I am missing something very simple.
Hello!
First some info:
Configurator version: 6.0.0
FC Firmware: 6.0.0 [SPEEDYBEEDF405V3]
FC: SpeedyBee F405 V3
ESC: 4in1 SpeedyBee F405 ESC Stack
Receiver: RP3 ExpressLRS
Other:
2x Cameras
Camera Switcher
GPS
VTX (SpeedyBee TX800)
24x WS2812 LEDs
Buzzer
I am in the configurator trying to set the wiring for my LEDs (like I did in version 5.0.0), but it isn't working! I click the "Wire Ordering Mode" button so the background changes to light green, but when I click the squares to set the wiring, nothing happens except for a pink highlight on the one that was clicked.
What is going on here? 🤔. I hope this is a simple issue arising from my incompetence lol.
I also tried setting up everything in the CLI, but that didn't seem to work either. I DO have "feature LED_STRIP" enabled.
Besides that issue, I am not sure how to attach my camera switcher to a RC channel, or even where to attach it on my FC ( I have it wired to S9 right now). I'm not sure where to ask that question though 🤷♂️.
Thanks in advance!
The text was updated successfully, but these errors were encountered: