You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
The settings page provides a "CNC/Spindle On" custom command. I assume that this is intended to dynamically replace the M3 command that programs such as FlatCAM assume for spindle control but where firmware/hardware is not setup this way (e.g. CyclonePCBs Marlin f/w).
However this appears to not be functioning as the host still sends M3, despite me filling in the above field with M42 S0 P12.
The text was updated successfully, but these errors were encountered:
The settings page provides a "CNC/Spindle On" custom command. I assume that this is intended to dynamically replace the M3 command that programs such as FlatCAM assume for spindle control but where firmware/hardware is not setup this way (e.g. CyclonePCBs Marlin f/w).
However this appears to not be functioning as the host still sends M3, despite me filling in the above field with M42 S0 P12.
The text was updated successfully, but these errors were encountered: