You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
configured some lightbulbs and switches using yahka on iobroker. These lighbulbs and Switches are running on the KNX bus. Here there are two different addresses / datapoints used for the "set" command and for the "state". In homebridge it is done by "set" and "listen" so two different datapoints can be defined. See Picture below:
So to have the correct behavior also in Homekit / yahka an additional characteristic for "state" within the Services would be needed.
There are devices that use the separate datapoint for state and other that use the set datapoint for both. For the second case yahka works already correctly.
Regards
Sven
The text was updated successfully, but these errors were encountered:
Hi,
configured some lightbulbs and switches using yahka on iobroker. These lighbulbs and Switches are running on the KNX bus. Here there are two different addresses / datapoints used for the "set" command and for the "state". In homebridge it is done by "set" and "listen" so two different datapoints can be defined. See Picture below:
![homebridge_knx](https://user-images.githubusercontent.com/6310971/42449340-d386820a-836f-11e8-800b-312050abb0fd.jpg)
So to have the correct behavior also in Homekit / yahka an additional characteristic for "state" within the Services would be needed.
There are devices that use the separate datapoint for state and other that use the set datapoint for both. For the second case yahka works already correctly.
Regards
Sven
The text was updated successfully, but these errors were encountered: